Digital Lumens Status Indicators

Digital Lumens Status Indicators

LED lighting fixtures

The status indicators for ILE, DLE, CLE, DLA-V and RLE fixtures are noted on the attached pdf.  The status indicators for the RLE and DLA-V are the same as the CLE.

Lighting Controls Sensors

For DLA-I/S/R/E/LLE/M sensors, he DLA will display a blink pattern once every 30 seconds.  This is due to the DLA being designed for lower mounting heights and office-type applications where a frequent blink pattern would be a nuisance.

 Red LED

  1. 1st second every 30 seconds
    1. Single blink: Normal operation, network connected
    2. Double blink: Normal operation, no network
    3. Fast blink: Temperature Throttling
  2. 2nd second every 30 seconds
    1. Single blink: Active State
    2. No blink: Inactive State
    3. Remain Seconds are Off

Blue LED

  1. Double blink: Unable to talk to one of the DALI fixtures for more than 20 seconds.
  2. Annoyingly fast blink: Over Temperature Shutdown

Both LEDs

  1. Constant Alternating: Fixture ID mode

No LEDs blinking for longer than 30 seconds

  1. Did you watch the sensor for at least 30 seconds?
  2. Is the sensor wired properly and receiving power?

    • Related Articles

    • Digital Lumens DIP Switch Settings

      ILEs, DLEs and CLE1-ST fixtures with serial numbers starting in 0A and hardware revision < rev 30 have DIP switches. Digital Lumens fixtures sold after 2020 do not have user configurable DIP switches. If the fixtures are new and have never been ...

    • Troubleshooting LED Lighting Fixtures

      Overview The following guide will provide troubleshooting steps that will not only remedy common issues that can arise, but also expedite the RMA process if troubleshooting is unsuccessful. Fixture Status The first step is to understand the status of ...