Commission a SCN-CLM

Commission a SCN-CLM

Before a SCN-CLM (CLM) will work with SiteWorx, it must be added to a Mapfile and commissioned to a gateway. This process is completed by installers or a commissioning agent using the Commissioner software program in combination with a USB wireless adapter. For more information about adding new devices, contact support@siteworx.io.

The process for commissioning a CLM is the same as other lighting devices as noted in the Methods of Commissioning Lighting Devices article. Once the sync is complete, the Commissioner status circle for the CLM will be purple and then Commissioner will then prompt you to Configure Lighting Sensors.

As the CLM does not have an integrated occupancy sensor, it has the following light output behavior:
  1. Before the CLM is connected to SiteWorx, the CLM will illuminate at the active level without dimming. 
  2. While connected to SiteWorx, the light output of the CLM can be controlled using neighboring occupancy sensors via Coordinated Control and Setback.
  3. If a CLM loses connection to SiteWorx or is power cycled and cannot immediately reconnect to SiteWorx, the CLM will illuminate at the active level as a safety measure.

    • Related Articles

    • Commission a TRH

      Before a Temperature and Relative Humidity sensor (TRH) will work with SiteWorx, it must be added to a Mapfile and commissioned to a gateway. This process is completed by installers or a commissioning agent using the Commissioner software program in ...

    • Commission a Keypad

      Before a keypad will work with SiteWorx, it must be added to a Mapfile and commissioned to a gateway. This process is completed by installers or a commissioning agent using the Commissioner software program in combination with a USB wireless adapter. ...

    • How to wirelessly commission replacement fixtures using Commissioner

      Overview This guide details the process for commissioning a replacement fixture following the removal and replacement of a malfunctioning fixture. If you are commissioning a new facility or a large quantity of replacement fixtures, then please visit ...

    • Commissioning Digital Lumens Fixtures Using a USB Cable

      Overview Commissioning via a USB cable requires physically connecting to each fixture. This method of commissioning is most suitable for users who infrequently use Commissioner and would like to program small numbers of fixtures. The most common ...

    • Commission a CRD

      Before you Begin Necessary Items Commissioner 3.4.1 or newer Workflow Add CRD to the mapfile Click Map Click Add SWN-CRD Add via Serial Number or Wireless Discovery Click Next Once Add SWN-CRD Dialog appears: Enter Descriptive Name Choose Zone Choose ...