Manual Fixture Control

Manual Fixture Control


Use this tool to help troubleshoot during initial commissioning. It's often used to confirm that dimming wiring is connected properly.

  1. Select a fixture on the map grid or in the fixtures tab
  2. Go to Edit > Advanced > Manual Fixture Control
  3. Move the slider control to change the fixture's output level (0-100)
  4. Click Done to exit

    • Related Articles

    • Troubleshoot Fixture Tool

      Use this tool when specifically requested by SiteWorx Support. Go to Edit > Advanced > Troubleshoot Fixture Select Connect Wirelessly and then choose the network on which the fixture resides OR connect to the fixture directly via USB cable and then ...

    • Read Fixture Information

      Use this tool to get historical information about a fixture, including kWh used, active time, and inactive time since the last fixture reset. This data is helpful for troubleshooting and may be requested by Support. Select a fixture on the map grid ...

    • 0-10V Fixture Characterization

      Overview Only follow this process if you experience issues with dimming after Lighting Sensor Configuration. Use the instructions below to create a custom 0-10V fixture characterization profile to use in place of the Default profile that's usually ...

    • Coordinated Control in Commissioner

      This article is intended for advanced Commissioner users only. Most users should modify Coordinated Control settings in SiteWorx Tune. More information can be found here. Learn more about Coordinated Control here. Overview This article is intended ...

    • Fixture Target

      The yellow target in the grid positions fixtures on the map grid. When you click and drag the target, and then add a fixture, that fixture lands in the target location. Also, you can right-click on the map and select Move Target Here to specify the ...