Commission a CRD

Commission a CRD

Before you Begin

Necessary Items

  1. Commissioner 3.4.1 or newer

Workflow

  1. Add CRD to the mapfile
    1. Click Map
    2. Click Add SWN-CRD
    3. Add via Serial Number or Wireless Discovery
    4. Click Next
  2. Once Add SWN-CRD Dialog appears:
    1. Enter Descriptive Name
    2. Choose Zone
    3. Choose Sensor Group (optional - will not appear in SiteWorx)
  3. Click Program Now to wirelessly program now with the DLUSB (if in range), otherwise click Program Later and commission it using the Sync command
 

    • Related Articles

    • Commission an RCP

      Before you Begin Overview The SWN-RCP is a plug load control receptacle that can function as an occupancy-based load controller, when used in conjunction with SiteWorx Tune and Sense. The SWN-RCP is a Zigbee 3.0 device and requires installation and ...

    • Commission a TRH

      Before a Temperature and Relative Humidity sensor (TRH) will work with SiteWorx, it must be added to a Mapfile and commissioned to a gateway. This process is completed by installers or a commissioning agent using the Commissioner software program in ...

    • Commission a SCN-CLM

      Before a SCN-CLM (CLM) will work with SiteWorx, it must be added to a Mapfile and commissioned to a gateway. This process is completed by installers or a commissioning agent using the Commissioner software program in combination with a USB wireless ...

    • Coordinated Control in Commissioner

      This article is intended for advanced Commissioner users only. Most users should modify Coordinated Control settings in SiteWorx Tune. More information can be found here. Learn more about Coordinated Control here. Overview This article is intended ...

    • Manual Fixture Control

      Use this tool to help troubleshoot during initial commissioning. It's often used to confirm that dimming wiring is connected properly. Select a fixture on the map grid or in the fixtures tab Go to Edit > Advanced > Manual Fixture Control Move the ...